Issue №: 3 (122)
The journal solves the problems of creation and improvement of machinery and technologies for agriculture: 131 - Applied Mechanics, 132 - Materials Science, 133 - Industrial Engineering, 141 - Power Engineering, Electrical Engineering and Electromechanics, 208 - Agricultural Engineering.
SIMULATION OF THE PROCESS OF VIBRATING SUNFLOWER DRYING
Igor Zozulyak – Candidate of Technical Sciences, Senior Lecturer of the Technological Department Processes and Equipment Processing and Food Productions Vinnytsia of the National Agrarian University (3, Solnyshchaya St., Vinnytsia, 21008, Ukraine, e-mail: zozulak@vsau.vin.ua, https:// orcid.org /0000-0002-5381-3115).
This work is devoted to the research and substantiation of the technology of drying sunflower seeds and the development of technological and technical proposals for the creation of drying equipment that would ensure work on this crop, both in seed and food modes.
The technological value of sunflower seeds is determined by their oil content. Therefore, it is important to preserve the quantity and quality of oil. Under optimal drying conditions, the oil content in sunflower seeds increases. Therefore, the question of selecting technological equipment for the drying process arises.
Analysis of the mechanical and technological parameters of series-produced dryers showed that these machines are mainly intended for the processing of grain crops. The disadvantages of well-known mine grain dryers are low moisture removal during one pass of the material through the dryer, overheating of the seed and a decrease in its quality in the area of contact with the surface of the intake boxes, increased fire hazard. Drum grain dryers when drying sunflower seeds are very fire-hazardous and do not allow obtaining seeds with uniform moisture content, and the use of high-temperature modes leads to a decrease in the sowing qualities of seeds due to overheating. When drying sunflower seeds in recirculation type dryers, it is very important to evenly distribute the seeds over the entire cross-section of the chamber, as well as to prevent the accumulation of oil dust in the heating chamber and to eliminate the ingress of sparks from the furnace into the heating chamber. One of the promising methods of drying bulk materials is the method of drying in a vibrating fluidized bed, which can be achieved on vibrating dryers of various types.
A number of experiments were conducted to substantiate the technological and technical proposals for the process of drying sunflower seeds and to determine the operating parameters of the dryer. Based on the results, graphs were constructed. The results of the research proved the expediency and necessity of using vibrating dryers during drying of sunflower seeds. The best parameters of the infrared radiation drying process with a selected wavelength of 1,5-3,0 μm , a sunflower seed layer height of 15 mm, and a heat flow density of IR radiation were found. 5 kW/m 2 , the height of the placement of the IR generator blocks relative to the layer of the irradiated product is 25 mm, while the drying time will be 11 minutes.
[1] Palamarchuk, I.P., Bernyk, P.S., Stotsko, Z.A., Yaskov, V.V., Zozulyak, I.A. (2006). Heat and mass exchange processes and equipment of processing and food production : training. Lviv : "Beskid Bit" Publishing House. [in Ukrainian].
[2] Zozulyak, I.A. (2020). Justification structural and technological parameters of the infrared vibrating dryer. Technology, energy and transport of the agricultural industry, 1 (108). 75–81. DOI: 10.37128/2520-6168-2020-1-9. [in Ukrainian].
[3] Zozulyak, I.A. (2014). Priming the structure of the vibrating machine for drying granular and granular materials. Similar European Journal of Advanced Technologies, 1/7 (67). 15–19. [in Ukrainian].
[4] Bandura, V., Zozuliak, I., Palamarchuk, V. (2014). Description of heat exchange in the similarity theory of vibrating drying process of sunflower. Ukrainian Journal of Food Science, 2(2). 305–311. [in English].
[5] Burdo, O., Bandura, V., Zykov, A., Zozulyak, I., Levtrinskaya, J., Marenchenko, E. (2017). Using of the wave technologies in intensification processes of heat and mass transfer. EUREKA: Physics and Engineering, 4. 18–24. DOI: 10.21303/2461-4262.2017.00399. [in English].
[6] Paziuk, V.M., Petrova, Z.O., Tokarchuk, O.A., Yaropud, V.M. (2019). Research of rational methods of drying rape seed. INMATEH-Agricultural Engineering, 58 (2). 303–310. [in English].
[7] Paziuk, V.M., Liubin, M.V., Yaropud, V.M., Tokarchuk, O.A., Tokarchuk, D.M. (2018). Research on the rational regimes of wheat seeds drying. INMATEH-Agricultural Engineering, 56(3). 39–48. [in English].
[8] Burdo, O.G., Bandura, V.N., Levtrinskaya, Yu.O. (2018). Electrotechnologies of targeted energy delivery in the processing of food raw materials. Surface Engineering and Applied Electrochemistry, 54 (2). 210–218. [in English].
About journal
131 - Applied Mechanics
132 - Materials Science
133 - Industry engineering
141 - Power engineering, electrical engineering and electromechanics
208 - Agricultural engineering
The magazine "Engineering, Energy, Transport AIC" is included in the list of scientific professional editions of Ukraine on technical sciences
(Category "Б", Order of the Ministry of Education and Science of Ukraine dated 02.07.2020 №886)
Old version of site: http://tetapk.vsau.edu.ua, http://techjournal.vsau.org
According to the decision of National Council of Television and Radio Broadcasting of Ukraine from 25.04.2024 No. 1337 the scientific journal «Engineering, Energy, Transport AIC» has the ID of the Media R30-05173.
The journal "Engineering, Energy, Transport AIC" is indexed according to the following databases and catalogs:
Certificate of state registration of mass media: No. 21906-11806 P dated 03/12/2016.
Founder of the journal: Vinnytsia National Agrarian University
Editor-in-chief: Oleksii Tokarchuk - Ph.D., Associate Professor, VNAU (Vinnytsia)
Deputy Editor-in-Chief: Natalia Veselovska - Doctor of Technical Sciences, Full Prof., VNAU (Vinnytsia)
Executive Secretary: Yuriy Polevoda- Ph.D., Associate Professor, VNAU (Vinnytsia)
Members of the Editorial Board:
Tokarchuk O.A. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Veselovska N.R. - Doctor of Technical Sciences, Full Professor, Vinnytsia National Agrarian University
Polevoda Yu.A. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Jordan Todorov Maximov - Doctor of Technical Sciences, Full Professor, Technical University of Gabrovo (Bulgaria)
Bulgakov V.M. - Doctor of Technical Sciences, Full Professor, Acad. NAAS, National University of Life and Environmental Sciences of Ukraine
Hraniak V.F. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Ivanchuk Y.V. - Doctor of Technical Sciences, Associate Professor, Vinnytsia National Technical University
Iskovich-Lototsky R.D. - Doctor of Technical Sciences, Full Professor, Vinnytsia National Technical University
Kupchuk I.M. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Sevostianov I.V. - Doctor of Technical Sciences, Full Professor, Vinnytsia National Agrarian University
Spirin A.V. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Tverdokhlib I.V. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Tsurkan A.V. - Doctor of Technical Sciences, Associate Professor, Vinnytsia National Agrarian University
Yaropud V.M. - Ph.D., Associate Professor, Vinnytsia National Agrarian University
Type of publication: journal
Kind of publication: scientific
Publication status: domestic
Year of foundation: 1997
Periodicity: 4 times per year
Volume: 18-20 conv. print. sheet (А4)
ISSN: 2520-6168 (print version), (online version)
Language of publication: (mixed languages) Ukrainian, English
The sphere of distribution and category of readers: national, foreign, faculty, scientists, entrepreneurs.
The periodical edition is included to the List of scientific professional publications of Ukraine on technical sciences, approved by order of the Ministry of Education and Science of Ukraine in 05.16.2016, No. 515.
The journal "Engineering, Energy, Transport AIC" is included in the "Catalog of Ukrainian Publications".
Subscription to the journal can be issued in each post office. The subscription index is 99720.
It was founded in 1997 under the title "Bulletin of the Vinnitsa State Agricultural Institute." According to the Decree of the Presidium of the Higher Attestation Commission of Ukraine of September 11, 1997, this publication received the status of a professional in which it is allowed to publish the main results of dissertation researches.
In 2001-2014 the journal published under the title “Collection of scientific works of Vinnytsia National Agrarian University. Series: Technical Sciences "(Certificate of State Registration of Mass Media KV No. 16644-5116 PR of 04/30/2010).
Since 2015 journal has title "Engineering, Energy, Transport AIC" (Certificate of State Registration of Mass Media No. 21906-11806 P dated 03/12/2016).